User Guide
45
Reference
Editing Macros
You can edit any macro you have recorded.
1 Tap and hold the MODE icon in the LOWER TOOL BAR
more than 3 seconds. Mode Menu page appears.
2 Tap the “MACRO” button to switch to MACRO mode.
The RC9500 displays first Macro mode page
.
3 Tap the “Macro to button” button if you want to edit the macro
for the operation button, or “Macro to device” button for the
device to proceed to the next step.
4 Navigate to the device and the page that contains the button
you want to edit a macro.
5 Tap the button which holds the macro you want to edit.
The “Macro edit” page appears.
6 You can Move or Delete the listed commands, or you can Add
new commands.
Tap “Add”
Browse to the page, choose button
Use the arrow buttons and to move the command to
the right place
7 You can also add delays and beeps to the macro (for example,
to insert a short pause between turning on a device and sending
commands to it, allowing the device to warm up).
The length of a delay can be adjusted:
Tap a delay.
Tap or buttons beside the list box to decrease or
increase the length of the delay.
8 Press the “Test” button to check if edited macro performs
properly.
9 Tap “Done” to store and finish editing.
DFU RC9500 Ver1_2.qxd 5/28/2004 10:33 AM Page 49