Filter
Top Products
User Guide
33
6 Edit the label.
To delete a character, press the
Right Function button labeled
“Del”.
To change the font size, Tap
the “+” or “-” buttons beside the
“Font” label on the page.
Note If the font size does not fit in
the button, the font size
cannot increase.
To enter a character, tap the
keyboard near the character you
want to use. The keyboard is zoomed in, allowing you to tap
exactly the character you need.
After you have tapped the character, the keyboard is zoomed
out. Repeat this action for every character.
Note You can zoom out again without tapping a character by
tapping the “Unzoom” button.
For capital characters and symbols, tap the “Shift” button
repeatedly to display the keyboard you want.
Note If you type a longer word than fits in the button, the font
size will automatically get smaller.
7 Tap “Enter” button to save the changes. You will be redirected
to the previous page.
-or-
Press the Left Function button labeled “Back” to return to the
page you were at without saving changes.
8 When you are finished labeling, you can return to the Mode
Menu page by tapping label in the LOWER TOOL BAR.
9 Return to USE mode by pressing the Left Function button
labeled “Exit”.
Note You cannot label buttons on the Device Overview page directly.
You have to label them using “Label device” function in the
LABEL mode. (see page 34)
Reference
DFU RC9500 Ver1_2.qxd 5/28/2004 10:33 AM Page 37