Filter
Top Products
User Guide
44
Reference
There are two extra commands you can record as any step in a
macro;
Recording a Device Action (Source or Input Switching)
To record a Device Action containing a source switching command,
open the Device Overview page, hold down the Right Function
button (labeled “Action”) and tap the device you want to record the
device action. This action places the entire Device Action in the
Macro.
Note If a Device action has been programmed as macro, you can
include all of the commands which were programmed in that
device action as a single step in another Macro, effectively
nesting one macro inside another.
Recording a Jump to a Device page
To jump to any device, open the Device Overview page or Page
Overview page, hold down the Left Function button (labeled
“Jump”) and tap the device/page you want to jump to. This action
places the jump to the selected device’s page in the Macro.
Recording a Macro to a Device Button (as the Device
Action) Step By Step
1 Tap and hold the MODE icon in the LOWER TOOL BAR
more than 3 seconds. Mode Menu page appears.
2 Tap the “MACRO” button to switch to MACRO mode.
The RC9500 displays first Macro mode page
.
2 Tap the “Macro to DEVICE” button to proceed to the next step.
The Device Overview page appears.
3 Tap the device you want to program a macro.
4 Complete steps 6 to 10 in “Recording a Macro to an Operation
Button” on page 43.
DFU RC9500 Ver1_2.qxd 5/28/2004 10:33 AM Page 48