Mitsubishi Electronics TM WD-62827 Projection Television User Manual


 
66 Chapter 5. TV Menu Operations
Setup Menu, continued
Timer
Figure 10
On/Off
The timer allows you to set up a time when the TV will
change the channel and turn on. You select the time and
day for the TV to turn on and the device and channel to
display. At your preselected time, the timer will turn the
TV on and this message will be displayed: “Press a button
for the TV to stay on.” Press any button on the remote
control within five minutes or the TV will turn itself off.
Figure 10. Timer Menu (Timer On/Off)
Set Day
Select the day or days that the TV will turn on
automatically. Press ADJUST or to select Daily,
Mon-Fri (Monday through Friday), or the individual days
of the week.
Set Time
Press ADJUST repeatedly to slowly select the hour or
press and hold to quickly select the hour. Press ENTER
to move to the minutes options. Press ADJUST or to
select minutes.
Device
Press ADJUST or to select the device to use when
the timer turns on the TV. If the TV is already on, the
timer will turn the TV to this selected device.
Channel
When an antenna is the selected device, you may select
any memorized channel. Press ADJUST or to
select the channel and the TV will tune to this channel in
memory when the timer turns it on. This includes sub-
channels for digital choices.
Lamp Reminder
Select to reset the lamp reminder message after you have
changed the lamp cartridge. Press ENTER, then press
ENTER again to confirm reset of the lamp reminder. To
have an accurate reminder that the lamp cartridge may
soon need replacement, reset the lamp reminder only
when you replace the lamp cartridge. See Appendix G
for detailed information about changing the lamp.
Software Version
For some service-related issues, it may be necessary to
know the software version in your TV. This information is
displayed on the Setup menu screen.
Time Zone
Select your correct time zone. Press ADJUST or to
select the time zone (Atlantic, Eastern, Central, Mountain,
Pacific, Alaska or Hawaii) for your area. Then press
ADJUST to move to the Daylight Savings time option.
Daylight Savings Time
Select the Daylight Savings time (DST) option that your
state uses. Press ADJUST or to select Applies if
your state or area uses DST, or Ignore if DST does not
apply.
Auto
Select the Time Zone and Daylight Savings time setting,
as noted above. You may then tune to a channel (on
ANT-1 or ANT-2) that uses Extended Data Service (XDS)
time data, typically a PBS channel. The Auto selection
will automatically retrieve the correct time and date
information from this channel. Be aware that if a channel
displays incorrect time information, it is because of
information sent from the broadcaster and is not a defect
of the TV.