Mitsubishi Electronics TM WD-62827 Projection Television User Manual


 
Chapter 7. Using the TV with a PC 93
CAUTION: To ensure continued FCC
compliance, the user must use a
shielded video interface or HDMI cable
with bonded ferrite cores at both ends
when using the PC input.
Computer with a 15-Pin Monitor
Output
Models WD-62927 and WD-73927
Figure 3
A 15-pin PC monitor cable and stereo audio cables are required.
These cables are not supplied.
1. Connect PC Monitor Out from the computer to
PC INPUT on the TV back panel using a 15-pin
PC monitor cable. See Appendix A for PC signal
compatibility.
2. Connect the L (left) and R (right) audio cables from
the computer to INPUT DVI Analog Audio 2 on the TV
back panel. If the computer’s audio output is a single
mini-jack, a mini audio-to-RCA-male “Y” adaptor
cable is needed to complete this connection.
Note: To receive the benefits of a digital A/V receiver,
connect your computer’s digital audio out, if available,
to a digital input on your digital A/V receiver.
$0.10/&/5
:1C1SJQQJ
*/165
47*%&0
7*%&0
"6%*0
-&'5
.0/0
"6%*0
3*()5
%57$"#-&
7)'6)'
%*(*5"-
"6%*0
065165
$BCMF$"3%
64&8*5)
"/5$"3%501
2
:
1C
1S
"6%*0
-&'5
.0/0
"6%*0
3*()5
065165
"6%*0
065165
3&$03%
065165
%7*
"OBMPH"VEJP
7*%&0
AUDIO-
LEFT/
(MONO)
"6%*0
3*()5
.0/*503-*/,)%.*
7*%&0JQQJ
"6%*01$.-*/&"3
*&&&
*/165
065165
/FU$PNNBOE
*3&.*55&3
¸
(-JOL
¸
*/165
1$'03)%.*
0/-:)[
7("87("
47("847("
9("9
64&8*5)
$BCMF$"3%
"/5."*/
"/5"69
.0/*503-*/,
$0/530-34$
1$*/165)[
7("87("47("
847("9("89("
99
JQQJ
:
1C
1S
"6%*0
-&'5
.0/0
065165
"6%*0
065165
3&$03%
065165
%7*
"OBMPH"VEJP
7*%&0
AUDIO-
LEFT/
(MONO)
"6%*0
3*()5
*/165
$PNQVUFSXJUI.POJUPS0VUQVU
57
Figure 3. Connecting a computer with monitor output.
Computer with a DVI Monitor Output
Figure 2
A DVI-to-HDMI cable or DVI/HDMI adaptor and HDMI cable and
audio cables are required. These are not included with the TV.
They may be available at your local electronics retailer.
1. Connect the DVI-to-HDMI cable (recommended) (or
DVI/HDMI adaptor with an HDMI cable) from the PC
DVI output to HDMI 2 on the TV back panel.
NOTE: If you are using a DVI/HDMI adaptor, it is
important to connect the adaptor to the DVI device
for best performance.
2. Connect the L (left) and R (right) audio cables
from AUDIO OUT on the PC back panel to INPUT/
DVI Analog Audio 2 on the TV back panel. If the
computer’s audio output is a single mini-jack, a mini
audio-to-RCA-male “Y” adaptor cable is needed to
complete this connection.
NOTE: The HDMI connection supports copy
protection (HDCP). Some devices require that you
connect to an analog input first before you can
view on-screen menus and select DVI as the ouput.
Please review your equipment instructions for DVI
connectivity and compatibility.
"6%*0065
-&'5
3*()5
$6)/54
$0.10/&/5
:1C1SJQQJ
*/165
47*%&0
7*%&0
"6%*0
-&'5
.0/0
"6%*0
3*()5
%57$"#-&
7)'6)'
%*(*5"-
"6%*0
065165
2
:
1C
1S
"6%*0
-&'5
.0/0
"6%*0
3*()5
065165
"6%*0
065165
3&$03%
065165
%7*
"OBMPH"VEJP
7*%&0
AUDIO-
LEFT/
(MONO)
"6%*0
3*()5
.0/*503-*/,)%.*
7*%&0JQQJ
"6%*01$.-*/&"3
*&&&
*/165
065165
/FU$PNNBOE
*3&.*55&3
¸
(-JOL
¸
*/165
1$'03)%.*
0/-:)[
7("87("
47("847("
9("9
64&8*5)
$BCMF$"3%
"/5."*/"/5"69
.0/*503-*/,
$0/530-34$
47*%&0
7*%&0
"6%*0
-&'5
.0/0
"6%*0
3*()5
%57$"#-&
7)'6)'
%*(*5"-
"6%*0
065165
:
1C
1S
"6%*0
-&'5
.0/0
"6%*0
3*()5
065165
"6%*0
065165
3&$03%
065165
%7*
"OBMPH"VEJP
7*%&0
AUDIO-
LEFT/
(MONO)
"6%*0
3*()5
.0/*503-*/,)%.*
7*%&0JQQJ
"6%*01$.-*/&"3
*&&&
*/165
065165
/FU$PNNBOE
*3&.*55&3
¸
(-JOL
¸
(-JOL
¸
(-JOL
*/165
1$'03)%.*
0/-:)[
7("87("
47("847("
9("9
64&8*5)
$BCMF$"3%
"/5."*/
"/5"69
.0/*503-*/,
$0/530-34$
)%.*
%7*UP)%.*
$BCMF
1$XJUI%7*0VUQVU
%7*
"OBMPH
"VEJP
57#BDL1BOFM
Figure 2. Connecting a Computer with DVI Monitor Output
Connecting a PC
IMPORTANT
After connecting the PC, activate the PC
option in NetCommand. Do this either during
initial NetCommand setup (in the Device Setup
screen), or at any time afterwards with the
NetCommand Add function. See chapter 3.
See Appendix A for signal compatibility.