2
ⅥⅥⅥ
†
PLASMA MONITOR
Important Information
Warnings and Safety Precaution
The NEC plasma monitor is designed and manufactured to pro-
vide long, trouble-free service. No maintenance other than clean-
ing is required. Use a soft dry cloth to clean the panel. Never use
solvents such as alcohol or thinner to clean the panel surface.
The plasma display panel consists of fine picture elements (cells).
Although NEC produces the plasma display panels with more than
99.99 percent active cells, there may be some cells that do not
produce light or remain lit.
For operating safety and to avoid damage to the unit, read care-
fully and observe the following instructions.
To avoid shock and fire hazards:
1. Provide adequate space for ventilation to avoid internal heat
build-up. Do not cover rear vents or install in a closed cabinet
or shelves.
The unit is equipped with cooling fans. If you install the unit in
an enclosure, be sure there is adequate space at the top of the
unit to allow hot air to rise and escape.
If the monitor becomes too hot, the overheat protector will be
activated and the monitor will be turned off. If this happens,
turn off the power to the monitor and unplug the power cord. If
the room where the monitor is installed is particularly hot, move
the monitor to a cooler location, and wait for the monitor to
cool for 60 minutes. If the problem persists, contact your NEC
dealer for service.
2. Do not use the power cord polarized plug with extension cords
or outlets unless the prongs can be completely inserted.
3. Do not expose unit to water or moisture.
4. Avoid damage to the power cord, and do not attempt to modify
the power cord.
5. Unplug unit during electrical storms or if unit will not be used
over a long period.
6. Do not open the cabinet which has potentially dangerous high
voltage components inside. If the unit is damaged in this way
the warranty will be void. Moreover, there is a serious risk of
electric shock.
7. Do not attempt to service or repair the unit. NEC is not liable
for any bodily harm or damage caused if unqualified persons
attempt service or open the back cover. Refer all service to
authorized NEC Service Centers.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER. NO USER-SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALI-
FIED SERVICE PERSONNEL.
This symbol warns the user that uninsulated volt-
age within the unit may have sufficient magnitude
to cause electric shock. Therefore, it is dangerous
to make any kind of contact with any part inside of
this unit.
This symbol alerts the user that important litera-
ture concerning the operation and maintenance
of this unit has been included. Therefore, it should
be read carefully in order to avoid any problems.
WARNING
TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EX-
POSE THIS UNIT TO RAIN OR MOISTURE. ALSO DO NOT
USE THIS UNIT'S POLARIZED PLUG WITH AN EXTENSION
CORD RECEPTACLE OR OTHER OUTLETS, UNLESS THE
PRONGS CAN BE FULLY INSERTED. REFRAIN FROM
OPENING THE CABINET AS THERE ARE HIGH-VOLTAGE
COMPONENTS INSIDE. REFER SERVICING TO QUALI-
FIED SERVICE PERSONNEL.
DOC compliance Notice
This Class A digital apparatus meets all requirements of the Ca-
nadian Interference-Causing Equipment Regulations.
WARNING
This equipment has been tested and found to comply with the lim-
its for a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful in-
terference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own
expense.
Precautions
Please read this manual carefully before using your NEC plasma
monitor and keep the manual handy for future reference.
CAUTION