Filter
Top Products
14
Before Use
The Worldwide model has a voltage selector for compat-
ibility with power systems around the world. Before you
plug in this model, make sure that the voltage selector is
set to the correct voltage for your area. If it isn’t, use a
small screwdriver to set it as appropriate. For example, if
the voltage in your area is 120 volts, set the selector to
“120V.” If it’s between 220 and 230 volts, set it to “220-
230V.”
Notes:
• The supplied batteries should last for about six
months, although this will vary with usage.
• If the remote controller doesn’t work reliably, try
replacing both batteries.
• Don’t mix new and old batteries, or different types of
batteries.
• If you intend not to use the remote controller for a long
time, remove the batteries to prevent possible leakage
and corrosion.
• Flat batteries should be removed as soon as possible to
prevent possible leakage and corrosion.
To use the remote controller, point it at the DV-SP1000/
DV-SP1000E’s remote control sensor, as shown below.
Notes:
• The remote controller may not work reliably if the
DV-SP1000/DV-SP1000E is subjected to bright light,
such as direct sunlight or inverter-type fluorescent
lights. Keep this in mind when installing the
DV-SP1000/DV-SP1000E.
• If another remote controller of the same type is used in
the same room, or the DV-SP1000/DV-SP1000E is
installed close to equipment that uses infrared rays,
the remote controller may not work reliably.
• Don’t put anything, such as a book, on the remote con-
troller, because the buttons may be pressed inadvert-
ently, thereby draining the batteries.
• The remote controller may not work reliably if the
DV-SP1000/DV-SP1000E is installed in a rack behind
colored glass doors. Keep this in mind when installing
the DV-SP1000/DV-SP1000E.
• The remote controller will not work if there’s an obsta-
cle between it and the DV-SP1000/DV-SP1000E’s
remote control sensor.
Setting the Voltage Selector
(Worldwide model only)
Installing the Remote’s Batteries
1
To open the battery compartment, press
the small hollow and slide off the cover.
2
Insert the three supplied batteries (AA/R6)
in accordance with the polarity markings
inside the battery compartment.
3
Put the cover onto the remote controller
and slide it shut.
OUT
AC INLET
D. MIX FRONT SURR
1
CENTER SURR
2
L
R
L
R
SUB
WOOFER
OUT
IN
REMOTE
CONTROL
VIDEO OUT
COMPONENT
S VIDEO VIDEO
Y
P
B
PR
1
+
21
RS
232
IR
S400
(
AUDIO
)
SURR MODE
(
AUDIO OUT
)
IN
12
V
TRIGGER
SUPER AUDIO CD & DVD AUDIO/
VIDEO PLAYER
MODEL NO. DV
-
SP
1000
YPB PR
COAXIAL OPTICAL OPTICALCOAXIAL
DIGITAL
1
DIGITAL
2
VIDEO
S VIDEO
HDMI
VIDEO IN
AUDIO OUT
HD VIDEO OUT
COMPONENT
AUDIO OUT
VOLTAGE SELECTOR
220-230
V
120
V
220-230
V
120
V
VOLTAGE SELECTOR
Using the Remote Controller
30˚
30˚
DV-SP1000/
DV-SP1000E
Approx. 16 ft.
(5 m)
Remote control sensor