Onkyo DV-SP1000 DVD Player User Manual


 
41
Connecting—Continued
Connect the IR receiver to the DV-SP1000/
DV-SP1000E as shown below.
Controlling Other Out-of-range
Components
For another component that is out of range of its remote
controller, you can use a commercially available IR
emitter to retransmit the remote controller signals
received at the DV-SP1000/DV-SP1000E’s IR IN, as
shown below.
Connect the IR emitter to the DV-SP1000/
DV-SP1000E’s IR OUT, and place the IR emitter in front
of the other AV component’s remote control sensor (usu-
ally located on its front panel), as shown below. See the
instructions supplied with the IR emitter.
Only remote controller signals received by the
DV-SP1000/DV-SP1000E’s IR IN are fed through to the
IR OUT. Signals picked up by the DV-SP1000/
DV-SP1000E’s remote control sensor are not.
Notes:
Before connecting the power cord, complete all of the
necessary audio and video connections.
Do not use a power cord other than the one supplied
with the DV-SP1000/DV-SP1000E, which is designed
exclusively for use with the DV-SP1000/
DV-SP1000E and should not be used with any other
component.
Never disconnect the power cord from the
DV-SP1000/DV-SP1000E while the other end is still
plugged into a wall outlet. Doing so may cause an
electric shock. Always disconnect the power cord
from the wall outlet first.
The DV-SP1000/DV-SP1000E (not the Canadian
model) is shipped with the POWER switch in the ON
position ( ). When the power cord is connected for
the very first time, the DV-SP1000/DV-SP1000E will
go on standby and the STANDBY indicator will light
up.
To completely shutdown the DV-SP1000/
DV-SP1000E, set the POWER switch to the OFF posi-
tion ( ). (This does not apply to the Canadian model).
OUT
IN
IR
DV-SP1000/DV-SP1000E
from connecting block
Miniplug cable
Signal flow
IR IN
IR OUT
Connecting
block
IR receiver
DV-SP1000/
DV-SP1000E
IR emitter
Remote controller
Other
component
Signal flow
OUT
IN
IR
Signal flow
DV-SP1000/
DV-SP1000E
Remote control
Other component
sensor
from connecting block
Miniplug cable
Miniplug
IR emitter
IR Emitter
Connecting the Power Cord
1
Plug the supplied power cord into the
DV-SP1000/DV-SP1000E’s AC INLET.
2
Plug the other end of the power cord into
a suitable AC wall outlet.
The STANDBY indicator lights up.
The STANDBY indicator comes on only if the
POWER switch is in the ON ( ) position. (This
does not apply to the Canadian model).
M
ODEL NO. DPC
-
7.4
DVD CHANGER
AC INLET