95
Troubleshooting—Continued
■ Abnormal Behavior
The DV-SP1000/DV-SP1000E contains a microprocessor for signal processing and control functions. In very rare
situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the
unlikely even that this should happen, unplug the power cord from the wall outlet, wait at least five seconds, and then
plug it back in again. Alternatively, press and hold the Stop [ ] button until “Reset” appears on the display (about 10
seconds).
■ Restoring the Default Settings
To reset the DV-SP1000/DV-SP1000E to its factory defaults, turn it on and, while holding down the Stop [ ] button,
press the [STANDBY/ON] button. “Initialize” appears on the display. When the reset is complete, “Complete” is
displayed, and the DV-SP1000/DV-SP1000E enters Standby mode.