Filter
Top Products
36
3. Setup
3-7. Network settings
Set up the network for transmitting image files by Ethernet. For details on image transmission method, refer to
“5. Image transmission functions”.
The network setup is: IP address: 192.168.0.10, subnet mask: 255.255.255.0 and gateway: 0.0.0.0 (unused).
When using the host computer with settings matching the network setup, it is not necessary to setup via the
menu.
For the setting to take effect, the system must be rebooted. Turn the system’s power off and then back on.
Setting the IP address
Press the [FUNC] switch to light its indicator, and then press the [SETUP] switch to display the SETUP
menu.
Turn [F1] to display the IP menu.
Turn [F2] to select the setting location. An asterisk ( ) appears at the setting location.
Turn [F3] to set the number, and press the [F3] switch to enter the setting. If the setting is not entered even
though it has been changed, “ ! ” appears above the setting location, and when the setting location is moved
by turning [F2], the value prior to the change is restored.
ＩＰ
７／１４
！＊
１９２．１６８． ０． １０
Setting the subnet mask
On the SETUP menu, turn [F1] to display the MASK menu.
Turn [F2] to select the setting location. An asterisk ( ) appears at the setting location.
Turn [F3] to set the number, and press the [F3] switch to enter the setting. If the setting is not entered even
though it has been changed, “ ! ” appears above the setting location, and when the setting location is moved
by turning [F2], the value prior to the change is restored.
ＭＡＳＫ
８／１４
＊
２５５．２５５．２５５． ０