Filter
Top Products
32
VQT2J51
Recording from an External Device
[RAM] [-R] [-R]DL] [-RW‹V›] [+ R] [+ R]DL] [+RW] [VHS]
≥Turn off the unit and other video equipment before connecting.
≥Refer to “Adding a VCR: Connecting to a Television and a Video
Cassette Recorder” when connecting to the AV2 input terminals on
the rear panel. (> 75)
§1
You can get a sharper, clearer picture by connecting with an S Video
cable instead of the yellow video cable.
§2
Connect to terminals of the same colour.
≥If the audio output of the external device is monaural, connect to L/
MONO on the AV3 input terminals at the front.
[RAM] [-R] [-R]DL] [-RW‹V›] [+ R] [+ R ]DL ] [+RW]
Perform steps 1 - 3 (> left).
[VHS]
Perform steps 1 - 3 (> left).
Tips
To skip unwanted parts
Press [;] to pause recording. (Press again to restart recording.)
To stop recording
Press [∫].
[RAM] [-R] [-R]DL] [-RW‹V›] [+R] [+R]DL] [+RW]
≥Using Flexible Recording (> 30), you can record the content of a
video cassette (approx. 1–8 hours) to a 4.7 GB disc with the best
possible quality of recording without wasting disc space.
Notes
≥When timer recording starts while recording from an external device,
timer recording takes priority and recording from the external device
stops.
≥If video is copied from another piece of equipment to this unit, then the
video quality will be degraded.
≥Almost all videos and DVD-Video on sale have been treated to
prevent illegal copying. Any software that has been so treated cannot
be recorded using this unit.
Preparation:
≥ Turn on the unit.
≥ [RAM] If the disc is protected, release protection
(> 64).
≥ [VHS] Ensure accidental erasure tab is intact.
≥ When the output signal from the external device is
NTSC, change the “TV System” to “NTSC” in the
Setup menu (> 70).
This unit cannot record NTSC signals to discs that
already have PAL signal recordings.
≥ To reduce noise in input from an external device, set
“Copy NR” to “On” in the on-screen display (> 63).
1
to select the DVD or VHS
drive.
– Insert a disc or video cassette with enough
remaining blank space (> 7).
2
to select the recording
mode (> 28).
3
to select the input where
your external device is connected.
– Front panel inputs are AV3.
S VIDEO
AV3 IN
VIDEO
/MONO
AUDIO
R
L
S VIDEO
IN 2
VIDEO
/MONO
AUDIO
RL
Audio/video cable
§2
S Video
cable
§1
Other video
equipment
Connect to Audio/Video output terminals.
This unit
DRIVE
SELECT
REC MODE
SELECT
INPUT
Recording to DVD
4
Start play on the external device.
5
at the point you want to start
recording to the disc.
Recording to VHS
4
to bring the tape to the
point at which you want to start
recording from.
5
when you reach that point.
6
to put the unit in recording
standby.
7
Start play on the external device.
8
to start recording at the point
you desire.
REC
PLAY
PAUSE
REC
PAUSE
DMR-EZ49VEB_VQT2J51.book 32 ページ ２００９年１２月２１日 月曜日 午後５時４０分