Filter
Top Products
44
Universal Remote Control (continued)
Learning the Codes Programmed Into the Remote
If you set up the Hard Disk Recorder remote by following “Searching for Your
Component’s Code” on page 43, you may want to figure out which four-digit
code is operating your equipment. Use this procedure after you set up your
components to find out which four-digit code is operating your equipment.
For example, to find out which code is operating your TV after setting up
your TV, follow steps below.
Learn your code.
1) For the first digit of your four-digit code, press 1 and
count the number of times the red LED blinks on the
remote.
2) For the second digit, press 2 and count the number
of times the red LED blinks on the remote.
3) For the third digit, press 3 and count the number of
times the red LED blinks on the remote.
4) For the fourth and final digit, press 4 and count the
number of times the red LED blinks on the remote.
• If the LED does not blink, the digit is zero.
Hold down CODE SET until the remote’s red
LED blinks twice, then release.
2
Press TV.
1
Press 9 - 9 - 0.
3
4
NOTE
• To find out the code for your other components, repeat steps
1~4, and substitute the appropriate device button (TV, SAT/
CABLE, or VCR/DVD) for the component code you wish to learn.
Re-assigning Component Mode
Buttons
You can program the Hard Disk Recorder remote component mode
buttons (TV, SAT/CABLE, or VCR/DVD) to control other home
entertainment components.
For example, to control a TV, a cable box, and a DVD player, you will need to
re-assign the VCR button to operate the DVD player, follow the steps below.
Hold down CODE SET until the remote’s red
LED blinks twice, then release.
a
Press 9 - 9 - 2. The red LED will blink twice.
b
You can now program the VCR/DVD button for your DVD player.
See “Setting Up Your Components” on page 42.
d
Press VCR/DVD twice. The red LED will blink twice.
c
To reassign other component mode buttons...
Repeat steps a~d by substituting the button sequence from
the list of popular components at right.
TV as 2nd
VCR button
TV as 2nd
CABLE button
TV back to TV
VCR as 2nd
TV button
VCR as 2nd
CABLE button
VCR back to VCR
Reassigning device keys
Press:CODE SET
9-9-2-VCR-TV
Press:CODE SET
9-9-2-CABLE-TV
Press:CODE SET
9-9-2-TV-TV
Press:CODE SET
9-9-2-TV-VCR
Press:CODE SET
9-9-2-CABLE-VCR
Press:CODE SET
9-9-2-VCR-VCR
Red LED
CODE SET
VCR/DVDc
SAT/CABLE
TV1
Number
buttons
2
a
3
4
b
PanaHDR- P42-.p65 00/11/28, 14:4744