Filter
Top Products
53
Specifications & Information
General
Operating voltage 120VAC 60Hz
Power Consumption 28W (Power On)
19W (Power Off)
Tuner
MTS
Input Connectors
Tuner Type F
Composite Phono x 2
Audio Phono (L+R) x 2
S-Video 4-pin miniature DIN
Output Connectors
Composite Phono x 2
Audio Phono (L+R) x 2
S-Video 4-pin miniature DIN
Telephone RJ-11, 2wire
Serial Control DB-9
IR Blaster
Dimensions/Weight
Height 76mm
Width 430mm
Depth 290mm
Weight (net) 5.9kg
Audio/Video Signals
Audio output level 2.0Vp-p
Video output level 1.0Vp-p
Video output impedance 75 ohm
Operating/Storage Conditions
Operating temp. range +5°C to +40°C
Storage temp. range -20°C to +55°C for 100 hours
Record
HDD Capacity 20.4GB
Video compression format MPEG2
Audio compression format MPEG1 layer2
Recording level Extended/Medium/High
Recording time 30H/15H/10H*
MODEM
Speed 56kbps
If the Hard Disk Recorder does not respond
when you press buttons on the remote, press
and hold the POWER button on the front of
the unit for 10 seconds. The Hard Disk
Recorder will start up in a few moments.
The Hard Disk Recorder’s green power LED
does not need to be lighted to record shows.
If you have a cable box or a satellite receiver,
however, these device must remain on for the
Hard Disk Recorder to record from them.
Resetting Hard Disk Recorder
Specifications
* Actual available recording time is not maximum because the
“Welcome Video” is already recorded in the Replay Guide.
To make the most of the available recording time, delete the
welcome video from the Replay Guide or save it to a
videotape.
When any image is displayed on a television
screen for an extended period of time, a
permanent mark can remain even after the
image is changed. This is called “screen burn
in.” Projection TVs are the most susceptible to
screen burn in. To prevent this, don’t leave the
Channel Guide, or any other screen displayed
when you don’t need to use them. You can
also adjust the brightness of the Hard Disk
Recorder screens to help prevent this. See
“Change Display Brightness” on page 7.
Screen Burn In
NOTE
• To dismiss the Pause on-screen image from your TV
screen and keep a show paused, press the EXIT
button on the remote control.
PanaHDR- P42-.p65 00/11/28, 14:4853