Filter
Top Products
6
Before Using
Make sure you have completed all the connections. (See pages 8~17.)
An instructional video is waiting for you to play directly from the Hard Disk
Recorder’s Replay Guide. To watch the video:
1.Once you complete the on-screen setup,
press REPLAY GUIDE on the remote.
2.Using the arrow buttons on the remote,
highlight the video titled “Welcome to Panasonic SHOWSTOPPER.”
3.Press PLAY on the remote.
You may use all of the Hard Disk Recorder’s television control features,
such as pause and rewind, while watching this video. All of the features
Watching the Welcome Video
covered in the instructional video are also referenced in this guide.
After you watch the video and are comfortable with the Hard Disk Recorder’s features, you may want to
save the video onto a videotape and delete the video from the Replay Guide. This will make more room for
recording shows. See “Saving Shows to Videotape” on page 39 for instructions on connecting the Hard Disk
Recorder to a VCR.
Occasionally, new features are added to the Hard Disk Recorder. These features are updated directly over
the telephone line you connect to the Hard Disk Recorder. As features change, you may encounter features
that perform differently from those in this guide. In general, follow the on-screen instructions if a feature is
not documented in this guide.
Hard Disk Recorder Feature Updates
The Hard Disk Recorder remote control requires two (2) new AA alkaline batteries.
NOTE: Removing the batteries will not require you to re-program your remote control.
AA
AA
1.On the back of the Hard
Disk Recorder remote,
pull back on the tab and
lift the battery cover off.
Installing the Batteries
2.Match the + and - marks on
the batteries to the + and -
marks in the battery case,
then insert the batteries.
4.Test the unit by pressing POWER.
If the batteries are inserted
correctly, the red light will blink.
3.Press the battery cover
back into place.
PanaHDR P01-.p65 00/11/28, 14:286