Filter
Top Products
[3D SETTINGS] menu
ENGLISH
- 71
Settings
[3D VIEWING MONITOR]
In the 3D video the depth of eld effects in front of and
into the screen are adjusted while conrming on the
monitor display.
1) Press the ◄► buttons to select [MODE1]
- [MODE3], and press the <ENTER>
button.
z
The parallax adjustment monitor is displayed.
The display content of each mode is described
below.
2) Press the ▲▼ buttons to select the
optimum parallax.
z
Press the <DEFAULT> button to return to
pre-adjustment settings.
z
Press the <FUNCTION> button to freeze and
unfreeze.
3) Press the <ENTER> button.
4) When you have nished making
adjustments, press the <RETURN>
button to return to [3D SETTINGS].
The display content of each mode in the parallax
adjustment monitor is as follows.
[Mode1]
Displays the parallax of the
entire image at the bottom of the
projection screen.
[Mode2]
Displays the maximum parallax
of the entire image in one
dimension.
[Mode3]
Displays the parallax of the
entire image by superimposing
on the image. (The image is in
monochrome signals, and only
the parallax is colored.)
Attention
z
If the red line of the in front of screen parallax descends
below the area demarcated by the reference line (white
dashed line) and the lower maximum line (white solid
line), or if the blue line of the into screen parallax ascends
above the area demarcated by the reference line (white
dashed line) and the upper maximum line (white solid
line), then make sure to watch from a large enough
distance from the screen or stop watching.
For explanation about each line, refer to the following
explanation for [Mode 1].
The lines on the parallax adjustment monitor in
[Mode1] display the following content:
White
(dashed line)
Default display for video without
parallax
Blue Displays the into screen parallax
Red
Displays the in front of screen
parallax
White
(solid line)
Displays an estimate for parallax of
general 3D video
Into screen
parallax
In front of
screen parallax
ADJUST
ƷƷ
ENTER : APPLY
ƷƷ
DEFAULT : RESET
ƷƷ
FUNCTION : FREEZE
This indicates the maximum estimate
in front of screen parallax while measuring.
This indicates the maximum estimate
into screen parallax while measuring.
Reference
line
* The illustration shown here depicts how an image is
projected.