Filter
Top Products
[LENS CONTROL] menu
76 -
ENGLISH
Settings
[H-AREA POSITION]
You can move the frame area horizontally, such as
aligning the right or left frame edge to the screen
edge.
Moving left
Moving right
For example, when projecting an overscanned 16:9
projection area at a 4:3 aspect ratio on a 4:3 aspect
screen, you can adjust the horizontal discrepancy
between the screen position and the video display
position.
16:9 projection area
4:3 screen
4:3 video display position
[V-AREA POSITION]
You can move the frame area vertically, such as aligning
the top or bottom frame edge to the screen edge.
Moving
downward
Moving upward
For example, when projecting an overscanned 16:9
projection area at a 2.35:1 cinema scope screen
movie on a 2.35:1 size cinema scope screen, you can
adjust the vertical discrepancy between the screen
position and the video display position.
2.35:1 cinema scope screen
size video display position
16:9 projection area
2.35:1 cinema scope screen
[LEFT MASKING AREA]
You can place a blank (mask) area in the left side edge on
the screen
.
Less More
z
Setting range: 0 to 70
[RIGHT MASKING AREA]
You can place a blank (mask) area in the right side edge on
the screen
.
Less More
z
Setting range: 0 to 70
[UPPER MASKING AREA]
You can place a blank (mask) area in the upper side edge
on the screen
.
Less More
z
Setting range: 0 to 70
[LOWER MASKING AREA]
You can place a blank (mask) area in the lower side edge
on the screen
.
Less More
z
Setting range: 0 to 70
Note
z
If it is set to [0], each masking function will be invalid.
z
The [MASKING AREA] function will be invalid when
adjusting the [COLOR MANAGEMENT] or [SPLIT
ADJUST] settings, when displaying the [TEST PATTERN]
or [WAVEFORM MONITOR], or when no signal is
detected.
z
During the display of 3D images, you cannot use [LEFT
MASKING AREA], [RIGHT MASKING AREA], [UPPER
MASKING AREA], [LOWER MASKING AREA].
[PROCESSING MESSAGE]
You can set whether to show or hide the execution
message during switching of lens settings.
Switch settings Switch settings
[ON] Show the execution message
[OFF] Hide the execution message