Filter
Top Products
[3D SETTINGS] menu
72 -
ENGLISH
Settings
The gauge display of the one-dimensional display on
the parallax adjustment monitor of [Mode2] or [Mode3]
indicates the following content:
Blue gauge
Displays the maximum value of the into
screen parallax
Red gauge
Displays the maximum value of the in
front of screen parallax
Triangular
point
Displays the peak of the parallax of the
entire image during the last one second
(left side: In front of screen parallax, right
side: Into screen parallax)
ADJUSTƷƷENTER : APPLYƷƷDEFAULT : RESETƷƷFUNCTION : FREEZE
MOVE DISPLAY
Peak of the in
front of screen
parallax
Peak of the
into screen
parallax
This indicates the maximum estimate
in front of screen parallax while measuring.
This indicates the maximum estimate
into screen parallax while measuring.
Reference
line
* The illustration shown here depicts how an image is
projected.
The parallax distribution display on the parallax adjustment
monitor in [Mode3] indicates the following content:
Blue display Displays the into screen parallax
Red display Displays the in front of screen parallax
ADJUSTƷƷENTER : APPLYƷƷDEFAULT : RESETƷƷFUNCTION : FREEZE
MOVE DISPLAY SUB MENU : CHANGE SENSITIVITY HIGH SENSITIVITY
* The illustration shown here depicts how an image is projected.
Note
z
In [Mode2] and [Mode3], the display position can be
moved left and right with the ◄ ► buttons.
z
In [Mode3], the detection level of the parallax can be
changed with the <SUB MENU> button. Low level and
high level can be switched by pressing the button each
time. The default setting is high level.
z
In the cases such as 3D video input has a very large parallax
or in dark scenes, the correct parallax may not be detected.
z
If the depth of eld effects in front of and into the screen
for the 3D video parallax are set stronger than the
target, this may cause some individuals to feel extreme
discomfort or fatigue. Adjust the parallax so as to not
exceed target displaying (white (solid line)).
z
When an action is performed such as switching the
power off and on, switching input, or switching the signal,
the parallax adjustment set becomes inactive.
z
When adjusting the parallax using the [3D VIEWING
MONITOR], the ends on both sides of the video are
masked. Also note that the aspect size is changed.
ADJUSTƷƷENTER : APPLYƷƷDEFAULT : RESETƷƷFUNCTION : CANCEL FREEZE
* The illustration shown here depicts how an image is
projected.
z
The [3D VIEWING MONITOR] is disabled during
keystone correction.
[3D MOTION REMASTER]
During the display of 3D images, a smooth operation
in which the continuity of parallax is maintained is
realized.
Switch settings Switch settings
[ON] Active
[OFF] Inactive
Note
z
This function is only active for 3D input signals and is
inactive for 3D video that has been converted from 2D to 3D.
z
When [FRAME CREATION] is [OFF], [3D MOTION
REMASTER] cannot be performed.
[3D SAFETY PRECAUTIONS]
A request message regarding 3D viewing is displayed.