Filter
Top Products
20 Pelco Manual C650M (12/98)
6.3 MAIN MENU
• DISPLAY
Sets the time/date and direction to search for a desired location on a tape.
• TIMER PROGRAM
Sets the timed recordings.
• RECORDING SET UP
Sets the alarm recording mode, alarm recording duration, and emergency
recording.
• REAR TERMINAL
Sets the number of frames or fields to record for CLK OUT, output signal of
CALL OUT terminal, and the MODE OUT terminal, etc.
• MAINTENANCE
Displays the power loss list and alarm list, etc. Initializes all menu settings.
Clears the power loss list and alarm list.
• FIRST TIME SET UP
Sets quasi v-sync, time/date, and VCR operation when the end of the tape is
reached.
6.4 DISPLAY MENU
6.4.1 Display Mode
This is where you set the display mode. (Set the current date and time in the First
Time Set Up menu. Refer to Section 6.9.2.)
DISPLAY MODE 1 Displays date and time.
DISPLAY MODE 2 Displays date, day of the week, present time, and recording
mode.
DISPLAY MODE 3 Displays nothing until an alarm recording starts—then date,
alarm recording number, etc. is displayed.
DISPLAY MODE 4 Displays nothing. Even in the case of alarm recording nothing
is displayed on the monitor.
During an alarm recording, the alarm recording number is displayed if the display
mode is set from 1 to 3.
6.4.2 Time Date Size
This is where you set the size of the letters in the day and time display.
SMALL The letters become small.
LARGE The letters become large.
Figure 7. Main Menu
<MAIN MENU >
DISPLAY
TIMER PROGRAM
RECORDING SET UP
REAR TERMINAL
MAINTENANCE
FIRST TIME SET UP
Use JOG to select,
and ENTER.
Press DISPLAY to exit.
<DISPLAY>
DISPLAY MODE 1
TIME DATE SIZE SMALL
Ex.<MODE 1>
01 - 01 - 97 00:00:00
Figure 8. Display Menu