Filter
Top Products
30 Pelco Manual C650M (12/98)
8.1.4.2 Recommended Number of Tape Uses
Video tape wears during use. Use a new cassette according to the following table.
Table D. Recommended Number Of Tape Uses
Recording Number Of Repeat Tape Uses
Time
Mode T-120 Cassette T-160 Cassette
2H 100 50
6H 100 50
L12H 60 30
L24H 35 17
8.1.5 Series Recording
You can do series recording by connecting two or more TLR2024 VCRs together.
When the tape in the first VCR reaches the end during recording, the tape in the
second VCR automatically begins recording.
1. Set REC IN on the Rear Terminal menu to SERIES.
2. Set CALL OUT on the Rear Terminal menu to WRNG•TAPE END.
3. Set TAPE END on the First Time Set Up menu to REWIND.
NOTES:
• Series recording may have a
short pause (up to five seconds)
when going from recorder A to
recorder B. However, if you set
CALL OUT in the Rear Terminal
menu to WRNG•REMAIN, this
delay is eliminated.
• When set in the above configu-
ration and the second VCR
reaches the end of the tape, the
first VCR automatically begins
recording. Connect the line
marked by [*1] in Figure 17 only
if you want the first VCR to begin
recording again. If not, do not
connect it.
• If a problem occurs (for example,
the motor malfunctions during re-
cording) in the first VCR, the sec-
ond VCR automatically begins
recording.
• Series recording will not work
during timer recording.
• When recording in series, set
CALL OUT in the Rear Terminal
menu to a mode other than
WRNG.
Figure 17. Connecting VCRs in Series
SET RST
IN
REC GND ALM MODE CLK CALL
OUT
SET RST
IN
REC GND ALM MODE CLK CALL
OUT
[*1]