Filter
Top Products
44 Pelco Manual C650M (12/98)
12.0 TROUBLESHOOTING
12.1 SELF-DIAGNOSTIC FUNCTION AND
WARNING DISPLAY
The VCR uses self-diagnostics to detect internal malfunctions during recording. If
one occurs, the VCR indicates it on the monitor and in the VCR’s fluorescent dis-
play.
Table E shows the type of malfunction corresponding to the warning display and the
action to take.
Table H. Warning Display and Actions
Fluorescent Monitor Cause Remedy To Turn Off
Display the Indication
END TAPE END The tape ends Rewind the tape and
during recording. press the EJECT button.
— NO SIGNAL Lack of video Check for loose
signal input*. connections.
— CHECK Tape/deck trouble.
* Lack of video input signal.
If the VCR is set to record and it does not detect an input signal, NO SIGNAL appears on the monitor and the call signal is output
from the rear terminal.
Check that the cable from the camera is not broken and camera’s power has not been lost.
First, check the cassette. If there seems to be nothing
wrong with it, try recording again. If “CHECK” is still
displayed, change the cassette with a new one and try
recording again. Otherwise, unplug the power cord and
contact the dealer.
Turn off the indication
on the fluorescent
display and on the
screen by pressing the
EJECT button or
rewinding the tape.
When a video signal is
restored or record mode
is cleared, the indication
on the screen turns off.