Filter
Top Products
Pelco Manual C650M (12/98) 29
8.1.2 Record Check Function
When the VCR is recording, press the PLAY button for more than 1.5 seconds and
then release. The tape rewinds a little and then plays back the recording just made.
When the tape reaches the spot where you pressed the PLAY button, the VCR
returns to record mode.
8.1.3 Audio Recording
Apply the specified line input signal to the AUDIO IN connector.
Normal sound is played back only when a tape recorded in 2H, 6H, L12H, or L24H
mode is played back in its respective mode.
The longer the recording time mode, the worse the sound quality becomes. In L24H
mode, the sound quality is such that speech can be heard.
8.1.4 Repeat Recording
When TAPE END on the First Time Set Up menu is set to REPEAT or ALARM•PROT
and the repeat recording mode is set (the REPEAT indicator is lit), the tape will
automatically rewind to the start when the end of the tape is reached. Recording will
begin again.
Table C shows what automatically happens when the tape ends during recording.
8.1.4.1 Number of Tape Uses
(Repeat Recording Times)
Displays the number of times a tape has been used when the TAPE END setting is
set to REWIND, REPEAT, or ALARM•PROT.
1. Press the DISPLAY button. The Main menu will appear.
2. Turn the JOG dial to select MAINTENANCE and turn the SHUTTLE ring to the
right. MAINTENANCE will appear on the display. REPEAT REC TIMES indi-
cates how many times a tape has been recorded on.
• The number of tape uses increments by one when the tape ends.
• The number of tapes uses is kept even if the AC power is disconnected,
provided the backup battery is fully charged.
• The number of tapes uses is reset when you replace the current tape
with another.
3. Press the DISPLAY button. The time will be displayed.
Table C. When Tape End is Reached
STOP REWIND REPEAT ALARM•PROT
The tape stops. The tape automatically The tape automatically
rewinds to the beginning rewinds to the beginning
and then stops. and recording resumes.
When there are
alarm recordings
on tape.
When there are no
alarm recordings
on tape.
The tape stops.
The tape automatically
rewinds to the beginning
and recording resumes.
NOTE:
On ALARM•PROT mode, a tape with alarm recordings can be used for repeat recording by ejecting and re-
inserting the tape.
<MAINTENANCE >
POWER LOSS LIST
ALARM LIST
ALL MENU INITIALIZE
POWER LOSS LIST CLEAR
ALARM LIST CLEAR
<REPEAT REC TIMES> 0
<ELAPSED TIME> 0H