Filter
Top Products
Pelco Manual C650M (12/98) 21
6.5 TIMER PROGRAM MENU
(program number) This number identifies the program. If the recording times of
two programs overlap, the higher program number has
priority.
DW Day of the week. DAY is used to record at the same time
every day. SPL (special) uses the start/end days selected
with SPECIAL DW at the bottom of the screen.
START/END The VCR uses a 24-hour display. 00:00 indicates midnight;
12:00, noon; and 15:00, 3 p.m.
HR This is the recording mode. SKIP indicates that timer record-
ing is not performed during the set period. In 2H, 6H, L12H,
and L24H mode, audio is also recorded.
<TIMER PROGRAM>
DW START END HR
1 - - - - - : - - - - : - - - - - -
2 DAY 08 : 40 17 : 25 L12
3 MON 22 : 00 22 : 50 L24
WED 22 : 00 22 : 50 L24
5 SPL 20 : 30 23 : 30 2
6 MON 10 : 10 11 : 15 SKIP
7 SUN 23 : 30 00 : 15 6
8 MON 21 : 00 21 : 54 L24
SPECIAL DW MON-FRI
Program
number
Day of the
week
Recording start time
Next day indicator
Recording end time
Recording mode display
Figure 9. Timer Program Illustration
6.6 RECORDING SET UP MENU
ALARM REC MOD Sets the alarm recording mode. When you turn the JOG dial, the
display switches in the following order: 2H, 6H, L12H, L24H,
2H. (Refer to Section 8.3.3 for programming instructions.)
ALARM REC Sets the length of the alarm recording period. When you turn the
DURATION JOG dial, the display switches in the following order: 1M
(minute), 2M, 5M, 10M, MAN1, MAN2, 15S (second), 30S, 45S,
1M. (Refer to Section 8.3.3 for programming instructions.)
EMERGENCY REC Sets the emergency recording mode, as follows:
• OFF – Starts alarm recording when the alarm signal is
received during recording.
• ON – Starts alarm recording when the alarm signal is
received, not only during recording but also when the
power is OFF or when the tape is stopped.
(Refer to Section 8.3.3 for programming instructions.)
NOTE:
Set the ALARM REC DURA-
TION to MAN2 to use with the
MX4000 Series Genex™ Multiplexer.
NOTE:
When using the MX4000 Se-
ries Genex™ Multiplexer, make sure
the EMERGENCY REC setting is
ON if the VCR is to record alarms only.
<RECORDING SET UP>
ALARM REC MODE 2H
ALARM REC DURATION 1M
EMERGENCY REC OFF
Figure 10. Recording Set Up
Menu