Pelco TLR3096 VCR User Manual


 
16 Pelco Manual C672M (2/01)
CONNECTING THE VCR TO A PC
REMOTE
RESET
IN OUT
AUDI
IN OUT
VIDEO
ALM RST GNDREC MODE CLK CALL
IN OUT
BATTERY OPEN
MIC
RS-232C CROSSED CABLE
RS-232C
IN TERMINA
L
PERSONAL
COMPUTER
RS-232C
TERMINAL
00418
Figure 8. VCR to PC Connection
1. Connect the RS-232C crossed cable to the PC’s RS-232C terminal.
2. Connect the other end of the cable to the VCR’s RS-232C IN terminal.
For instructions on how to set the RS-232C interface board setting, refer to the
Assigning
the RS-232C Settings
section.
CONNECTING TO A PC FOR REMOTE CONTROL
You can remotely control the VCR using a personal computer that has an RS-232 serial
port.
Physical Protocol of RS-232C
Table A. RS-232C Protocol
Signal Line Directions
No. Names Meanings (from VCR side)
2RDReceive data INPUT
3SDTransmit data OUTPUT
4ERData terminal ready OUTPUT
5SGSignal ground --
6DRData set ready INPUT
7RSRequest send OUTPUT
8CSClear to send INPUT
Data Communication Settings
Synchronization: Asynchronous
Transmission rate: 1200/2400/4800/9600 bps
Data bit length: 8bit/7bit
Stop bit length: 1bit/2bit
Parity bit: None/Even/Odd
Xcontrol: Nil
S parameter: Nil
CS-RS handshake: With
Delimiter code for send: CR(0DH)/CR(0DH)+LF(0AH)
Delimiter code for receive: CR(0DH)/CR(0DH)+LF(0AH)
IMPORTANT:
Before
connecting the hardware,
unplug the VCR’s power
cord from the wall outlet,
and turn off the PC.
DB9 MALE
54 321
98 67
RS-232C
00384