Filter
Top Products
Pelco Manual C672M (2/01) 29
RECORDING SET UP MENU
Refer to the
Programming for Alarm Recording
section for programming instructions for the
following fields.
ALARM REC MODE Sets the alarm recording mode.
• If TAPE LENGTH in the First Time Set Up menu is set
to T-120, the display switches in the following order
when you turn the JOG dial: 6H, L18H, L30H, 8H.
• If set to T-160, the display switches in the following
order when you turn the JOG dial: 8H, L24H, L40H, 8H.
ALARM REC DURATION Sets the length of the alarm recording period. When you turn
the JOG dial, the display switches in the following order: 1M
(minute), 2M, 5M, 10M, MAN1, MAN2, 15S (second), 30S,
45S, 1M.
EMERGENCY REC Sets the emergency recording mode, as follows:
• ON – Starts alarm recording when the alarm signal is
received (ALM IN terminal grounded), not only during
recording but also when the power is off, when the tape
is stopped, or when the VCR is in standby mode for
timer recording.
• OFF – Starts alarm recording when the alarm signal is
received (ALM IN terminal grounded) during recording.
SUPER RESOLUTION Sets super resolution mode, as follows:
• ON – Recording and playback happen at more than
400 lines of resolution.
• OFF – Recording and playback happen at VHS mode.
ONESHOT•FIELD Sets the number of recorded fields in one-shot recording
mode. When you turn the JOG dial, the displays switches in
the following order: 1, 2, 3, 4, 5, 10, 20, 30, 1.
ONESHOT•INTERVAL Sets the time interval in one-shot recording mode. When you
turn the JOG dial the display switches in the following order:
SHOT, 10S (second), 15S, 30S, 45S, 1M (minute), 2M, 3M,
SHOT.
00394
<RECORDING SET UP>
ALARM REC MODE 8H
ALARM REC DURATION 1M
EMERGENCY REC OFF
SUPER RESOLUTION ON
ONE SHOT •FIELD 1
ONE SHOT •INTERVAL SHOT
Figure 18. Recording Set
Up Menu
NOTE:
When using the
MX4000 Series Genex Mul-
tiplexer: set ALARM REC
DURATION to MAN2, and
make sure EMERGENCY
REC is set ON if the VCR is
to record alarms only.