Filter
Top Products
Pelco Manual C672M (2/01) 37
RECORDING
MANUAL RECORDING
00362
REMOTE
PICTURE
SOF SHARP
REC/PLA
Y
TRACKING
JOG/ADJUST
EJECT REC
SHUTTLE
CLEAR/
REW
ENTER/
FW
MENU
/
TIME DATE ADJUST
PLAY/
REC CHECK
COUNTER
RESET
PAUSE/
SUTTLE HOLD
STOP
SEARCH TIMER REC
POSITON/
VERTICAL
ADJUST
7
10
9
8
1
2
3
400
5
4
6
1. Turn on the VCR and peripheral devices.
2. Load a cassette with the erasure prevention tab intact.
3. Press MENU button. The Main menu appears.
4. Turn the JOG dial to select RECORDING SET UP, and then turn the SHUTTLE ring
right. The Recording Set Up menu appears.
5. Turn the JOG dial to select SUPER RESOLUTION, and then turn the SHUTTLE ring
right.
6. Turn the JOG dial to select ON, and then turn the SHUTTLE ring right.
7. Press the MENU button. The day and time display appears on the monitor.
8. Press the REC/PLAY MODE mode to select the desired recording mode. (Refer to
Table D for recording and playback times.)
9. Press the REC button to begin recording.
10. Press the STOP button to stop recording.
Keep the following in mind:
• Press the PAUSE button to momentarily stop recording. Press again to resume
recording.
•To protect the tape, pause mode is automatically cancelled after about five minutes.
• If the tape you insert in the VCR has its erasure prevention tab removed, the VCR will
eject it if you try to record on it.
• The REC button will not function unless the VCR is in stop or pause mode.
•A tape recorded on this VCR may or may not play back correctly on another VCR.
NOTE:
Perform steps 3
through 7 to activate super
resolution recording mode.
Otherwise, skip to step 8.