Filter
Top Products
34 Pelco Manual C672M (2/01)
SET THE DAY AND TIME
Keep the following in mind:
•You must set the day and time before performing timer programming.
• The year 2000 is shown as 00.
• The clock is in 24-hour format.
• The alarm recording counter appears only during alarm recording.
Do the following to set the day and time:
1. Press the MENU button to display the Main menu on the monitor.
2. Turn the JOG dial to select CLOCK/FIRST TIME SET UP, and then turn the SHUTTLE
ring right. The First Time Set Up menu appears.
3. Turn the JOG dial to select TIME DATE ADJUST, and turn the SHUTTLE ring right.
The Time Date Adjust menu appears.
4. Turn the JOG dial to set DAYLIGHT SAVINGS, and then turn the SHUTTLE ring right.
The daylight saving item flashes.
• When set to ON, the clock advances one hour.
• When set to AUTO, the clock advances one hour from the first Sunday in April (at
2 a.m.) to the last Sunday in October (at 3 a.m.). Remember: Programmed
recordings starting or ending in the daylight savings time changeover period may
not be recorded correctly.
• When set to ON or AUTO and the clock advances one hour, the daylight savings
time symbol ( ) is displayed next to the present time display. The daylight
savings time indicator (❚) is illuminated on the fluorescent display.
Daylight savings time may vary from the one above depending on your region or the
year. In this case, set DAYLIGHT SAVINGS to ON or OFF manually.
When DAYLIGHT SAVINGS is set to ON or OFF and there is no tape in the VCR, you
can toggle DAYLIGHT SAVINGS to ON and OFF on the VCR’s front panel by
simultaneously pressing the STOP and EJECT buttons.
5. Turn the JOG dial to set the month, and then turn the SHUTTLE ring right.
6. Set DAY, YEAR, and TIME the same way. Year digits can be set from 97 (for year
1997) to 27 (for 2027).
Do the following if you want to set the time to the exact second. Set the minute digits
one minute ahead of the time you are using as a reference. The digit on the right will
flash and the seconds digits stay at 00. Turn the SHUTTLE ring right when the time
reaches 00 seconds of the time you set. The time will begin counting from 00.Turn the
JOG dial to set the day, and then turn the SHUTTLE ring right.
7. Turn the SHUTTLE ring right while the 1-minute digit in TIME is flashing. Programming
is now complete. The First Time Set Up menu appears.
8. Press the MENU button. The day and time display appears.
00357
<MAIN MENU>
DISPLAY
TIMER PROGRAM
RECORDING SET UP
REAR TERMINAL
MAINTENANCE
CLOCK/FIRST TIME SET UP
Use JOG to select,
and ENTER.
Press MENU to exit.
00383
00358
<TIME DATE ADJUST>
DAYLIGHT SAVINGS OFF
MONTH 01
DAY 01
YEAR 2000
TIME 00:00:00
NOTE:
If power goes out
while daylight savings time
is selected, the power failure
mark “X” replaces the day-
light savings time symbol.
When the power failure
mark “X” disappears, the
daylight savings time sym-
bol reappears.
00359
<TIME DATE ADJUST>
DAYLIGHT SAVINGS OFF
MONTH 01
DAY 01
YEAR 2000
TIME 00:00:00
NOTE:
The POWER but-
ton will not operate if any
menu display is flashing.