28 Pelco Manual C672M (2/01)
TIMER PROGRAM MENU
00393
<TIMER PROGRAM>
SPECIAL DW MON-
PROGRAM NUMBER
DAY OF THE
RECORDING START TIME
RECORDING END TIME
NEXT DAY INDICATOR
RECORDING MODE DISPLAY
Figure 17. Timer Program Illustration
This is where you set the program number, day of the week, starting and ending times, and
the recording mode. (Refer to the
Timer Recording
section for more detailed information
and procedures.)
(program number) This number identifies the program. You can set up to eight
programs. If the recording times of two programs overlap, the higher
program number has priority.
DW Day of the week. DAY is used to record at the same time every day.
SPL (special) uses the start/end days selected with SPECIAL DW at
the bottom of the screen. HLD is used to control recording on
holidays (20 maximum).
START/END The VCR uses a 24-hour display for starting and ending recording
times. 00:00 indicates midnight, 12:00 is noon, and 15:00 is 3 p.m.
An indicator between the START and END columns shows that
recording continues to the following day.
HR This is the recording mode. SKIP indicates that timer recording is
not performed during the set period. Recording mode varies by the
TAPE LENGTH set in the First Time Set Up menu.