Filter
Top Products
Pelco Manual C672M (2/01) 43
HOLIDAY SET UP
Up to 20 days a year can be set as days to perform timer recording. Or you can specify up
to 20 days when timer recording will not be performed during the programmed period by
setting HR in the Program To Record menu to SKIP.
1. Press the MENU button. The Main menu appears.
2. Turn the JOG dial to select TIMER PROGRAM, and then turn the SHUTTLE ring right.
The TIMER PROGRAM menu appears.
3. Turn the JOG dial to select HOLIDAY SET UP, and then turn the SHUTTLE ring right.
The Holiday Set Up menu appears.
4. Turn the JOG dial to move the cursor right to select the month you want, and then turn
the SHUTTLE ring right.
To erase the preset month and day, turn the SHUTTLE ring left while the month item
is flashing.
5. Turn the JOG dial to select the day you want, and then turn the SHUTTLE ring right.
Repeat steps 4 and 5 to set two or more days at once.
6. Press the MENU button. The day and time display appears.
SPECIAL DW SETTINGS
You can set the recording period by specifying the start and end day of the week for timer
recording.
1. Press the MENU button. The Main menu appears.
2. Turn the JOG dial to select TIMER PROGRAM, and then turn the SHUTTLE ring right.
The Timer Program menu appears.
3. Turn the JOG dial to select SPECIAL DW, and then turn the SHUTTLE ring right.
4. Turn the JOG dial to set the start day of the week, and then turn the SHUTTLE ring right.
5. Turn the JOG dial to set the end day, and then turn the SHUTTLE ring right. The start
and end days cannot be set to the same day.
6. Press the MENU button. The day and time display appears.
OVERLAPPING PROGRAMS
When the recording period of two or more programs overlap, the VCR always gives priority
to the higher-numbered program.
WHAT IF THE TIMER RECORDING INDICATOR STARTS
FLASHING?
Do the following if the timer recording indicator starts flashing:
1. Press the TIMER REC button to turn off the timer recording indicator.
2. The flashing indicator can mean:
•A tape is not inserted. Remedy: Insert a tape.
•A tape without an erasure prevention tab is inserted. Remedy: Insert a tape with
an erasure prevention tab.
• The day and time have not been set. Remedy: Set the day and time (refer to the
Adjusting the Clock
or
Set the Day and Time
section).
• The timer program has not been set. Remedy: Confirm the program.
•A menu item has been set (flashing). Remedy: Turn the SHUTTLE ring right to
stop the flashing.
3. Press the TIMER REC button to turn on the timer recording indicator.