18 Pelco Manual C672M (2/01)
CONTROLS
FRONT PANEL
00419
POWER
PICTURE
SOF SHARP
REC/PLA
Y
TRACKING
JOG/ADJUST
EJECT REC
SHUTTLE
CLEAR/
REW
ENTER/
FW
MENU
/
TIME DATE ADJUST
PLAY/
REC CHECK
COUNTER
RESET
PAUSE/
SUTTLE HOLD
STOP
SEARCH TIMER REC
POSITON/
VERTICAL
ADJUST
3 4 5
6
7
16 17
15
141312111098
1
2
FLUORESCENT
DISPLAY
400
Figure 9. Front Panel
1. POWER button
Press for on; press again for off. The POWER indicator lights when the VCR is turned
on.
2. Cassette loading slot
Insert the cassette in this slot to load it.
3. SHUTTLE ring
Use to adjust the playback speed and to program the menus. Turn this ring to the right
to advance the tape or to forward search. Turn it to the left to rewind a tape or to
reverse search. You can also use it to clear the alarm list, power loss list, timer
recording, and to initialize the menu programming. It also lets you program or exit the
menus after setup.
4. JOG dial
Use to advance or reverse the tape frame-by-frame and to program the menus.
5. MENU/TIME DATE ADJUST button
• When the VCR is turned on, press to display the Main menu. Press again to exit
the menu.
• When the VCR is turned off, press for more than three seconds and you can
adjust the VCR’s time and date on the fluorescent display.
6. PLAY/REC CHECK button
• When the VCR is in stop mode, press to play back a previously recorded tape.
• During recording, press for more than 1.5 seconds to check the recording
function.
7. STOP button
Press to halt all tape-related functions.
8. PICTURE control
Use this control to adjust picture quality between soft and sharp.
9. REC/PLAY MODE buttons (+/-)
Press to select the recording or playback speed.
10. TRACKING buttons (+/-)
Press to reduce or eliminate noise during playback, slow playback, etc.