70 Pelco Manual C672M (2/01)
BEFORE CALLING FOR SERVICE
If you cannot solve your problem after checking the following list, stop using the VCR,
unplug it from the outlet, and contact your dealer.
SYMPTOM REMEDY
INSTALLATION PROBLEMS
No power at the VCR. • Is the power cord disconnected at the AC outlet?
• Is the lock or lock all indicator lit? Refer to the
separate Caution sheet. See your supervisor if the
sheet is not attached to this manual.
• Is the timer recording indicator lit? Press the TIMER
REC button on the front panel to cancel timer recording.
The VCR power is on • Is the lock or lock all indicator lit? Refer to the
but the unit does not separate Caution sheet. See your supervisor if the
operate. sheet is not attached to this manual.
• Safety devices are operating. Press the RESET button
on the rear panel using a ballpoint pen or pencil. Turn
power on again.
No picture on the • Are the monitor and camera connected properly?
monitor. Check the connection.
• Is the video cable connected properly? Is the cable
defective? Check the connection and for a snapped
wire in the cable.
Picture on the monitor Is the camera focused? Refer to your camera’s user
is not clear. manual and focus the camera properly.
FUNCTION/OPERATION PROBLEMS
No operation when • Is the lock or lock all indicator lit? Refer to the
any tape operation separate Caution sheet. See your supervisor if the
button is pressed. sheet is not attached to this manual.
• Is a cassette inserted?
The time is wrong Make sure the VCR has AC power supplied continuously
even though the VCR for at least 40 hours per week.
is used every day.
The power cord was • Make sure the VCR has AC power supplied
disconnected for less continuously for at least 40 hours per week.
than 31 days but the
time has been reset. • Contents stored in memory may be erased before
the 31 days depending on the charge time of the
power failure compensation circuit. Set the time again.
A tape cannot be Is the lock all indicator lit? Refer to the separate Caution
loaded. sheet. See your supervisor if the sheet is not attached to
this manual.