Filter
Top Products
58 Pelco Manual C672M (2/01)
USING WITH A PC
Refer to the
Connecting the VCR to a PC
and
Connecting to a PC for Remote Control
sections for information about connection, protocol, data communication settings, and cable
connections.
ASSIGNING THE RS-232C SETTINGS
Assign the RS-232C interface board setting using the VCR’s on-screen menu, as follows:
1. Press the MENU button. The Main menu appears.
2. Turn the JOG dial to select CLOCK/FIRST TIME SET UP, and then turn the SHUTTLE
ring right. The First Time Set Up menu appears.
3. Turn the JOG dial to select RS-232C, and then turn the SHUTTLE ring right. The RS-
232C menu appears.
4. Change the parameter value by turning the JOG dial left or right, and then turning the
SHUTTLE ring right to store the new value.
• Set all parameters for the VCR to the same values as the controlling PC or other
equipment.
•PARITY BIT cannot be used when DATA BIT LENGTH is set to 8BIT.
• When controlling only one VCR via the PC, set VCR ADDRESS to NONE.
• VCRs can be remotely controlled via a PC when each VCR has a unique VCR
ADDRESS (from VCR01 to VCR255).
5. Repeat step 4 until all the items are set. The First Time Set Up menu appears after
setting VCR ADDRESS.
6. Press the MENU button. The day and time display appears on screen.