Filter
Top Products
User Guide
32
Customizing Pronto NG
3To set the switch level for a bright environment, position the
indicator at the left side of the light level bar.
The backlight will switch on only in a dark environment.
4To set the backlight always off, position the indicator at the far left.
3 Tap again.
The Light Level button is deselected. The new level for the light sensor is set.
Note The timeout of the LCD backlight also determines when the LCD backlight
switches on and off. Therefore, if you set the threshold to the left side of the light
level bar, the backlight does not switch off immediately.
Setting the Volume Level
You can set the volume level for the hard buttons as well as for the touch screen
buttons. The volume of the button refers to the loudness of the beep you hear
when you press or tap a button.
Setting the Volume Level of the Hard Buttons
To adjust the volume of the hard buttons, tap in the second
Settings Page.
You can either select 1 of the 3 volume levels or choose to mute. Every time
you press, the volume level increases with one step up to level 3.
Setting the Volume Level of the Touch Screen
To adjust the volume level of the touch screen, tap in the
second Settings Page.
You can either select 1 of the 3 volume levels or choose to mute. Every time
you tap, the volume level increases with one step up to level 3.
Setting the Navigation for Pronto NG
The cursor is used by default to operate your devices. You then navigate the Pronto
NG with the touch screen buttons. However, you can also set the cursor to browse
through Pronto NG’s devices and pages. For more information on operating the
Pronto NG with the cursor, see ‘Operating Pronto NG with the Cursor’ on page 44.
To set the navigation for the Pronto NG, tap in the second
Settings Page:
■ You can select Cursor Navigation-Off to navigate the Pronto NG with the
touch screen buttons.
■ You can select Cursor Navigation-On to navigate the Pronto NG with the
cursor.
Pronto TSU3000v3 US 18-02-2004 16:02 Pagina 32