Filter
Top Products
97654438 E
Page 29
EP006047
Manually Closing the Drive's Baseplates
3) Ensure that the primary AC power cord is disconnected from the wall outlet and that the
power switch on each drive is set to the OFF position ( O ).
4) Open each drive's media access door. Manually push each shuttle all the way to the left as
shown in the next figure and insert the small foam shipping blocks to hold the shuttle in
place. Close each media access door.
NOTE
If a media access door is locked, refer to the Removing the Bezel
procedure to manually override the door lock solenoid.
UPPER
ACCESS
HOLE
REAR PANEL
LOWER
ACCESS HOLE
MANUAL RELEASE
TOOL