Filter
Top Products
PLASMON LASER MAGNETIC STORAGE - LF 6602 USER MANUAL
Page 38
When only one LF 6602 is being interconnected with a host, one of the SCSI interface cables is connected
to the lower connector of the first drive. A terminator is connected to the lower connector of the second
drive to terminate the bus when the LF 6602 is the last or only SCSI device on a SCSI bus.
SINGLE-DEVICE CONFIGURATION
To connect SCSI cables and a terminator on a single LF 6602:
1) Plug one end of the SCSI interface cable into the vacant SCSI interface connector on the
host.
2) Route the other end of the SCSI interface cable from the host, under the LF 6602's cabinet
and up to the lower connector of the first drive. Install the cable into that connector.
3) Ensure that the shorter Plasmon LMS-supplied SCSI cable connecting the two drives is
securely fastened to the connectors. This cable connects from the first drive's upper
connector to the second drive's upper connector.
4) Install a SCSI terminator into the lower connector of the second drive.
EP006084
SCSI Cable and Terminator Configuration for the LF 6602
SCSI
CONNECTORS
PLASMON LMS
SUPPLIED CABLE
TERMINATOR
SCSI
CABLE