Filter
Top Products
97654438 E
Page 67
Diagnostic Menu (Part 2)
SET THE INTERNAL DRIVE SERIAL NUMBER ("SET SERIAL #")
To enter the serial number submenu, press the TEST/SELECT switch while "Set Serial #" is displayed in
the Main menu. The drive will enter the menu allowing the operator to view and change the internal drive
serial number.
NOTE
The serial number set in the drive must correspond to the last 5 digits
of the drive's actual serial number for accurate internal event logging
to occur. The drive's actual serial number is located on the back of the
drive enclosure.
To change the drive's 5-digit serial number, follow these steps:
1) Enter the Configuration mode by simultaneously pressing the LOAD/MENU and TEST/
SELECT switches.
2) Press the MENU switch until "Set Serial #" is displayed.
3) Press the SELECT switch to enter the serial number mode. The serial number will be
displayed.
View RTPM
SELECT
MENU
Display RTPM
Information
Clear RTPM
SELECT
MENU
Confirm Clear
RTPM
True
No RTPM Err
SELECT
RTPM Condition is Cleared
Y
N
Init DPC
SELECT
Init Done
Reset Drive
Self Test
PRESS BOTH
SWITCHES
SIMULTANEOUSLY
TO RETURN TO
MAIN MENU
"Set Config"
MENU
A