Filter
Top Products
97654438 E
Page 83
OPERATOR MAINTENANCE
ACCESSING DRIVES
During operator maintenance, if you need to extend and access a drive through the front of the LF 6602,
perform this procedure:
1) Disconnect a drive from the shipping bracket at the rear of the LF 6602 by unfastening the
four M4 screws (see figure below).
EP006031A
Disconnecting a Drive from the Shipping Bracket
2) Pull off the cabinet's trim panel (see next figure).
3) Press down on the front release levers of one drive's rack mount slide and pull the drive
out, away from the cabinet.
An interlock is incorporated into the design of the LF 6602's front panel to allow the extension of only one
drive at a time. If the interlock is defeated and if both drives are extended simultaneously on their rack
mount slides, the cabinet will become unbalanced and will topple over.
SHIPPING
BRACKET