Filter
Top Products
97654438 E
Page 63
VIEWING DIAGNOSTIC RESULTS OR PERFORMING DIAGNOSTIC
OPERATIONS ("DIAGNOSTICS")
To enter the diagnostic submenu, press the TEST/SELECT switch while "Diagnostics" is displayed in the
Main menu. The drive will enter the Diagnostics menu which includes the following options:
"Park Drive" Press the SELECT switch to park the baseplates for drive shipment. If the
"Park Failed, Close Manually" message appears, refer to the Manual Release
section of this manual. Press the MENU switch to select the next option in the
Diagnostics menu.
"Test Sensors" Press the SELECT switch to enter sensor display mode. In sensor display
mode the DOC panel will display the status of the sensors within the drive.
For details, see the LF 6600 Hardware Maintenance Manual (P/N 97653979).
Press the MENU switch to select the next option in the Diagnostics menu.
"Clear NvRAM" CAUTION
Since the initialization variables cannot
be recovered once they are cleared, this
operation should only be performed by a
trained Customer Engineer (CE).
Press the SELECT switch; the message "Drive will reset and NvRAM will be
cleared! To Continue Press Select" will appear. Press the MENU switch if you
do not want to clear the nonvolatile memory (NvRAM) initialization variables;
press the SELECT switch to clear the NvRAM initialization variables in the
drive. Press the MENU switch to select the next option in the Diagnostics
menu.
“Cal Shuttle” Press the SELECT switch to enter the Cal Shuttle option. This option allows
alignment of the load pin to the center of the cartridge track. If the shuttle
requires calibration, press SELECT to continue the calibration procedure.
Follow the instruction displayed at the DOC. During the calibration procedure,
the message “Align Slot “1 and “Close Door” will alternate at the DOC. When
the cal procedure has been completed, press LOAD/MEDIA switch to return
to the MAIN menu.
"View CDEs" Press the SELECT switch to view the controller detected error (CDE). The
DOC will display the error code. When no error has occurred, the "No CDE
Error" message is displayed. The error code is cleared upon exiting the
Diagnostics menu. The error code should be logged by the operator for aiding
the CE in diagnosing the drive problem. Press the MENU switch to select the
next option in the Diagnostics menu.