Filter
Top Products
97654438 E
Page 87
3) Gently pry the fuse holder open. Slide the fuse holder out of the receptacle and visually
inspect the active fuse to determine if it is blown. If the active fuse is blown, proceed to
step 4); otherwise, proceed to 5).
4) Remove the active fuse and discard it. Remove the spare fuse from its storage location
and insert the fuse between the fuse housing and the retaining clip.
5) Re-install the fuse holder into the receptacle, sliding the holder into the receptacle until the
holder is aligned flush with the receptacle housing.
6) Refer to the Power -On Procedure section.
7) If power is not restored, check the other fuse.
WARNING
If a spare fuse blows immediately after you have replaced the original
fuse, contact your next level of support.
Do not replace the spare fuse.
This may be a symptom of a more serious problem, either with the
drive's power supply or with the system power.
MEDIA CLEANING
Media disk surfaces should be inspected periodically and cleaned on an as-needed basis.
MEDIA CLEANING USING CLEANING KIT P/N 97662550
The Cleaning Kit P/N 97662550 provides a semi-automated cleaning method for cleaning the Plasmon
LM 4000 and LM 6000 12 inch optical media. Follow the instructions given in the enclosed Cleaning
Instructions.
The Kit contains the following items:
• One 12 inch media cleaning fixture
• One container of cleaning liquid
• One package of 500 cleaning tissues
• One pair of latex gloves
• Cleaning Instructions