Filter
Top Products
PLASMON LASER MAGNETIC STORAGE - LF 6602 USER MANUAL
Page 86
Perform the following procedure to clean the fan filter elements:
1) Unlock and open the cabinet door.
2) Set each drive's AC power switch to the OFF ( O ) position and verify that the fan and
blower have stopped running.
3) Remove each Outer Grill Half by grasping its sides and pulling it away from the chassis.
4) Remove each Filter Element by pulling it away from the inside of the Grill.
5) Wash each Filter Element in warm soapy water.
6) Rinse each Element thoroughly and let it air dry.
7) Re-install each Filter Element in the Outer Grill Half.
8) Replace the Outer Grill Half by snapping it onto the Inner Grill half.
REPLACING FUSES
As stated in the AC Power Requirement section of this manual, two fuses and two spare fuses are
integrated into the power receptacle on the rear panel of each LF 6600 (refer the next figure). If the drive
will not power up, one or both of the fuses may have blown.
To replace a blown fuse with a spare fuse for each drive:
1) Set the drive's AC power switch to the OFF ( O ) position and remove the AC power cord.
2) Insert a small, flat-blade screwdriver between the fuse holder and the receptacle housing,
as shown in the next figure.
EP006079
Removing Fuse from AC Power Receptacle (Rear View of Unit)
FUSE
SPARE FUSE
FUSE HOLDERS