Filter
Top Products
97654438 E
Page 79
REMOVING THE BEZEL
NOTE
A T15 screwdriver is required for removing the bezel assembly.
1) Release the electrical safety door lock by inserting the flat handle end of the manual
release tool through the slot in the bezel and move the locking lever to the left out of the
door lock tab as shown below.
EP006037
Manually Overriding the Door Lock
2) Open the media access door and remove the M4 x 20 mounting screw. Unplug the door
safety switch cables at the chassis and remove the bezel assembly by pulling it up and
away from the lower mounting tabs on the chassis as shown in the figure below.
CAUTION
Ensure that you do not damage the door safety switch cables when
you are removing the bezel.
RETRACT LOCK
MECHANISM BY
PULLING BACK HERE
DOOR LOCK MECHANISM
DISENGAGED
DOOR LOCK MECHANISM
ENGAGED