Filter
Top Products
CinemaWall Installation/Operation Manual 11
PRE
L
IMINAR
Y
3.1
Remote Control
To install batteries in the remote control:
1. Press on the tab on the battery compartment cover and lift the cover in the direction
of the arrow.
2. Insert the included batteries. Ensure that the polarities correctly match the and
markings inside the battery compartment.
3. Close the battery compartment cover and press the tab on the cover until it clicks in
place.
Notes on Batteries• When installing batteries, make sure that the battery polarities are correct.
• Do not mix an old battery with a new one or different types of batteries.
• If you will not use the remote control for a long time, remove the batteries to avoid
damage from battery leakage.
• Do not drop the remote control or expose it to moisture or high temperature.
• The remote control may malfunction under a fluorescent lamp. If that occurs, move the
plasma display away from the fluorescent lamp.
• Make sure that there is nothing obstructing the infrared beam between the remote
control and the IR receiver on the plasma display.
• If the effective range of the remote control decreases, or it stops working, replace the
batteries with new ones.
• Ambient conditions may possibly impede the operation of the remote control. If this
happens, point the remote control at the plasma display and repeat the operation.
3. Installation
+
-
+
-
12
“AA” size
3
The signal from the remote control can be reflected by walls or
other surfaces.
Note