Filter
Top Products
Operation
CinemaWall Installation/Operation Manual 37
PRE
L
IMINAR
Y
SOUNDUse the controls in the SOUND menu to adjust the CinemaWall audio settings.
To return all SOUND menu settings to their factory-default values, press RESET on the
remote control unit with the menu on-screen. Or, press or repeatedly to highlight
RESET in the menu, then press the ACTION ( ) button.
AUDIO MENU: The CinemaWall provides three audio memories for storing and recalling
sound quality settings. To store settings in an audio memory, highlight
AUDIO MENU in
the SOUND menu and select STANDARD, DYNAMIC or CLEAR. The CinemaWall
“remembers” any adjustments you make when you switch to a different audio memory,
then switch back.
BASS/MID/TREBLE: Use these controls to boost or cut the low, mid-range and high
frequencies respectively in the audio signal.
BALANCE: To adjust the left/right speaker balance, select BALANCE from the SOUND
menu. Use the or buttons to make one channel louder than the other.
SURROUND: The CinemaWall has a “surround sound” mode that simulates a
multi-channel sound system. To use the surround mode, select
SURROUND from the
SOUND menu and set it to ON.
AUDIO OUT (PIP): To swap the main and PIP audio programs when using the
MULTI
PIP feature, select AUDIO OUT (PIP) from the SOUND menu and set it to either
MAIN or SUB. For more on MULTI PIP mode, refer to MULTI PIP SETUP on page 43.
1. 1:1 PIXEL MODE is available only when the input signal is 1080i
or 1080p and the Aspect Ratio is set to 16:9 (refer to page 23).
2. You cannot adjust H-SIZE, V-SIZE or DOT CLOCK when 1:1
PIXEL MODE is enabled.
Note
AUDIO MENU DYNAMIC
BASS 0
MID 0
TREBLE 0
BALANCE 0
SURROUND ON
AUDIO OUT (PIP) MAIN
SOUND
R
E
S
ET
ADJUST
SELECT
RETURN
RESET
NO
RMA
L