Filter
Top Products
Operation
40 CinemaWall Installation/Operation Manual
PRE
L
IMINAR
Y
• START TIME/SHOW DURATION: When the screen saver MODE is TIME OF DAY,
set START TIME to the time of day that you want the screen saver to activate. When
the screen saver
MODE is INTERVAL, set SHOW DURATION to the “normal
presentation” interval (no screen saver).
Press or to change the SHOW DURATION interval in 15-minute increments, or to
change the START TIME in one-minute increments. Press and hold or to change
the START TIME interval in 15-minute increments.
• FINISH TIME/SAVER DURATION: When the screen saver MODE is TIME OF DAY,
set FINISH TIME to the time of day that you want the screen saver to deactivate. When
the screen saver
MODE is INTERVAL, set SAVER DURATION to the desired screen
saver interval.
Press or to change the SAVER DURATION interval or FINISH TIME in one-minute
increments. Press and hold or to change the SAVER DURATION interval or
FINISH TIME in 15-minute increments.
• SIDE BAR ADJUST: Do not display
an image in 4:3 mode for an extended
period, as this can cause image
retention in the inactive areas of the
display. The same is true of P OUT P
and P AND P multi-screen modes.
To help prevent this, select SIDE BAR
ADJUST from the SCREENSAVER
menu and set it to BRIGHT. (Other
choices are OFF, DARK and MID.)
• WOBBLING/PEAK LIMIT: These functions, when enabled, provide additional
protection against image retention.
• WOBBLING: WOBBLING automatically shifts the display image (in a manner
unnoticeable to the eye) to prevent image retention. ON1 shifts the image every 30
seconds; ON2 shifts the image at a dot level pitch depending on screen detection.
• PEAK LIMIT: PEAK LIMIT suppresses image contrast (peak brightness).
COMPONENT/RGB IN SELECT: Select COMPONENT/RGB IN SELECT from the
SET UP menu to choose the color space of the for RGB and component source signals.
INPUT LABEL: You can give each CinemaWall input a descriptive name, to indicate the
type of component connected to it (for example, “DVD3” instead of “INPUT3”). To do this,
select
INPUT LABEL from the SET UP menu and choose one from the list.
1. To deactivate the screen saver at any time, press RETURN ( )
on the remote control unit, or cycle power to the CinemaWall.
2. You must set the day and time in order to use the INTERVAL or
TIME OF DAY screen saver mode; refer to
Setting the Day and
Time on page 21.
Note
RETURN
side bars
4:3 mode
image
retention
P OUT P P AND P
Inactive areas