Filter
Top Products
Operation
CinemaWall Installation/Operation Manual 51
PRE
L
IMINAR
Y
Power On Screen Delay: In a large video wall installation, it may be advisable to turn the
displays on one at a time rather than all at once, so as not to overload the power source.
To make this easier, you can set the CinemaWall to wait up to 30 seconds after you press
the POWER button to turn itself on. To do this, select
Power On Screen Delay from the
OPTIONS menu. Select from 1 to 30 seconds of delay. For example, in a 2x2 video wall
you might set a 4-second delay on display “A1,” an 8-second delay on display “A2,” a
12-second delay on display “A3” and no delay (Off) on display “A4.”
Clock Display: To have the CinemaWall display the time of day (in addition to the current
input and aspect ratio) when the RECALL button is pressed, select
Clock Display from
the OPTIONS menu and set it to On.
All Aspect: This option controls which aspect ratio selections are available to the viewer.
Set it to On to allow the viewer to select all of the aspect ratios described in
Table 4-1. If
the viewer does not need that level of aspect ratio control, set it to Off for the sake of
simplicity.
Rotate: If the CinemaWall is suspended from a ceiling, you may want to mount it upside
down and run the cables upward (toward the ceiling) to make them less visible. If you do,
select
Rotate from the OPTIONS menu and set it to On to rotate the displayed image and
OSD menus 180 degrees.
Serial Slot Select: This menu option does not currently apply to the CinemaWall.
4.9
Using Digital Zoom
The CinemaWall allows you to zoom in on a
portion of the displayed image. To use this
feature:
1. Press the MOVE/ZOOM ( ) button.
2. An on-screen guide appears. Press the
ACTION (
) button to select a zoom level
(x1, x2, x3 or x4).
3. Press , , or to select an area of the
image to enlarge. The on-screen guide
shows you the selected area as you do this.
4. To return to normal viewing mode, press RETURN ( ) or MOVE/ZOOM ( ).
During the delay period, the power indicator flashes green.
Until you set the day and time (refer to Setting the Day and Time
on page 21), the Clock Display setting has no effect.
Note
Note
1
EXIT
RETURN