Filter
Top Products
Operation
CinemaWall Installation/Operation Manual 49
PRE
L
IMINAR
Y
Initial VOL level: Select Initial VOL level from the OPTIONS menu to set the desired
sound volume level upon power-up.
Press or to set it to On, then use the VOL- or VOL+ ( ) button to set the desired
initial volume level. When you do, the volume changes so you can preview your selection
before exiting the menu.
Maximum VOL level: Select Maximum VOL level from the OPTIONS menu to prevent
the sound volume from being set higher than a preferred threshold.
Press or to set it to On, then use the VOL- or VOL+ ( ) button to set the
maximum volume level. When you do, the volume changes so you can preview your
selection before exiting the menu.
INPUT lock: Select INPUT lock from the OPTIONS menu to allow only the selected input
to be displayed and prevent the others from being selected. Set it to Off to allow any input
to be selected.
Button lock: This menu option does not currently apply to the CinemaWall.
Remocon User level: Select Remocon User level from the OPTIONS menu to restrict
OSD menu access via the remote control. Choose one of the following:
•Off: No restriction. All remote control buttons are functional.
•User1: Only the POWER, INPUT, RECALL, SURROUND, MUTE, VOL- and VOL+
remote control buttons are functional.
•User2: Only the POWER button is functional.
•User3: Disables the remote control altogether.
Off-timer function: Select Off-timer function from the OPTIONS menu to enable or
disable the OFF TIMER ( ) remote control button (see Figure 2-4).
You cannot set the Initial VOL level higher than the Maximum VOL
level (see below).
1. If you set the Maximum VOL level lower than the Initial VOL level
(see above), the Maximum VOL level is set automatically set
equal to the Initial VOL level.
2. The volume display can go up to 63 regardless of the Maximum
VOL level setting. However, increasing the volume setting
beyond the Maximum VOL level has no effect.
Use this feature with caution. Once you select User3, the only
way to change it to something other than User3 is via the serial
command OSP:RCM0, OSP:RCM1 or OSP:RCM2. Refer to
Serial
Communications on page 55 for more information.
Setting Off-timer function to Disable cancels the Off-timer if it is
currently active.
RETURN
Note
RETURN
Note
Caution
Note