Filter
Top Products
Operation
44 CinemaWall Installation/Operation Manual
PRE
L
IMINAR
Y
• TRANSPARENCY/TRANSPARENCY LEVEL: If you are using the Blend PIP feature,
you can make the overlay (sub) image transparent so that the main (background) image
shows through.
To do this, select TRANSPARENCY from the MULTI PIP SETUP menu and set it to ON.
Then, select TRANSPARENCY LEVEL from the MULTI PIP SETUP menu to control the
degree to which you want the main image to show through.
• INSERT/INSERT LEVEL: If you are using the Blend PIP feature, you can divide the
overlay (sub) image into transparent and non-transparent areas. The CinemaWall then
“inserts” only the non-transparent areas of the overlay image into the main
(background) image.
To use this feature, select INSERT from the MULTI PIP SETUP menu and set it to ON.
Then, select INSERT LEVEL from the MULTI PIP SETUP menu to set the brightness
level threshold for distinguishing between the transparent and non-transparent areas of
the overlay image.
TRANSPARENCY cannot be used when INSERT is set to ON.
INSERT cannot be used when TRANSPARENCY is set to ON.
A B C D
A B C D
A B C D
TRANSPARENCY = 50%TRANSPARENCY = 0% TRANSPARENCY = 90%
Note
A B C D A B C A B C D
INSERT LEVEL = 5%INSERT LEVEL = 1% INSERT LEVEL = 10%
Note