Filter
Top Products
Operation
CinemaWall Installation/Operation Manual 39
PRE
L
IMINAR
Y
• XGA MODE (INPUT3/PC INPUT only): You can force the CinemaWall to use a
specific output resolution with RGB PC sources. To do this select
XGA MODE from the
SIGNAL menu and set it to 1024x768, 1280x768 or 1366x768.
• NOISE REDUCTION: To apply noise reduction to the source signal, select NOISE
REDUCTION from the SIGNAL menu. Noise Reduction is useful for clearing up noisy
images from interlaced SD sources. Set it to OFF, MIN, MID or MAX as needed. Or, if
you need more precise control over noise reduction, set it to ADVANCED, then press
to access the following controls:
• Video NR: Video NR is temporal and spatial noise reduction for all types of inputs.
The scene is analyzed for differences from frame to frame and reduces those
differences that are not determined to be motion.
• Block NR: Use this control to reduce or eliminate so-called “block artifacts” in
MPEG-compressed video signals (digital broadcasts or DVDs). Set it as needed to
minimize distortion within horizontal and vertical block boundaries.
• Mosquito NR: Use this control to reduce or eliminate so-called “mosquito noise” in
MPEG-compressed video signals. Set it as needed to minimize distortion around the
edges of moving objects, moving artifacts around edges and/or blotchy noise
patterns superimposed over the objects.
SCREENSAVER: Select SCREENSAVER from the SET UP menu to configure the image
burn-in prevention settings on the CinemaWall.
• FUNCTION: Select MODE from the SCREENSAVER menu and choose one of the
following burn-in prevention methods:
• NEGATIVE IMAGE: An inverse image is displayed on the screen.
• SCROLLING BAR ONLY: The source image is replaced by a white bar scrolling
from left to right.
• OVERLAY SCROLLING BAR: The source image is dimmed and a white bar
scrolling from left to right is superimposed on it.
• WHITE SCREEN: The source image is replaced by a white screen.
• MODE: Select MODE from the SCREENSAVER menu to specify when the screen
saver function becomes active.
• OFF: The screen saver is disabled.
• INTERVAL: The screen saver function becomes active after the selected SHOW
DURATION and remains active for the selected SAVER DURATION (see below). This
cycle repeats indefinitely.
• TIME OF DAY: The CinemaWall activates the screen saver function daily at the
selected START TIME and returns to normal operation at the selected FINISH TIME
(see below).
• ON: Select ON to activate the screen saver on demand. Then, press or
repeatedly to highlight START in the menu and press the ACTION ( ) button.
To prevent image retention (burn) on your display, ALWAYS use a
screen saver and set it to the shortest possible time.
OVERLAY SCROLLING BAR cannot be selected when MULTI PIP
is active.
WARNING
Note