Filter
Top Products
CinemaWall Installation/Operation Manual 21
PRE
L
IMINAR
Y
4.1
Turning on the Power
1. Turn on your source components.
2. Press the main power switch on the CinemaWall (see Figure 2-1 or Figure 2-2). The
standby/on indicator lights green.
3. After a brief warm-up period (approximately five seconds), the CinemaWall will display
an image.
4. Press the POWER button on the remote
control to put the CinemaWall into standby
mode. The power indicator lights solid red.
5. Press the POWER button again to return to
normal operation.
4.2
Changing the OSD
Language
The CinemaWall OSD language is initially set to English, but can also display the menus in
Russian, German, French, Italian or Spanish. To change the OSD language:
1. Press SET UP on the remote control unit.
2. Press repeatedly until OSD LANGUAGE is highlighted.
3. Press or to select the desired language. The change takes effect immediately.
4.3
Setting the Day and
Time
You can program the CinemaWall to perform various actions, such as turning on or off, at
specific times of the day and days of the week. In order to take advantage of this
capability, the CinemaWall internal clock must be set correctly. To do this:
1. Press SET UP on the remote control unit.
2. Press or repeatedly until PRESENT TIME SETUP is highlighted.
3. Press the ACTION ( ) button.
4. Press or repeatedly to highlight DAY
in the menu.
5. Press or to select the current day of
the week.
6. Repeat Steps 4 and 5 to set the current
time of day.
7. Press or repeatedly to highlight SET
in the menu, then press the ACTION ( )
button.
4. Operation
DAY TUE
PRESENT TIME OF DAY 10:00
PRESENT TIME OF DAY MON 99:99
PRESENT TIME SETUP
SELECT
RETURN
SET
SET