Filter
Top Products
E60
Instructions for attaching a VESA-compliant mount
An arm or stand based on the VESA standard
(commercially available) can be attached to the TV.
Procurement of the arm or stand is at the
customer's discretion.
Arms or stands able to be used
Attachments must satisfy the following.
- Compatible with the VESA standard.
- The six screw holes on the section to be
attached have a gap of 100 mm between them.
- Not be likely to fall off or break off after being
attached to the TV.
How to attach the arm or stand
- Be careful not to over bend the cable or add
extension cords as this could lead to a
malfunction.
- While following these instructions, please also
refer to the installation instructions in the
operation manual included with the arm or
stand.
- Because the TV is heavy, we recommend that
you perform the operation with two or more
persons including yourself.
CAUTION!
- Be careful not to get your fingers pinched
between the display and stand nor to let the
stand drop. These could lead to injury.
- Do not cover or block ventilation openings since
insufficient ventilation can cause overheating.
1.Turn off the TV power using the POWER button
on the TV.
2.Remove the terminal covers and the cables.
See page E10 for information on removing the
terminal cover.
3.Spread out a soft cloth on a flat surface.
Being careful not to damage the TV, gently lay
the TV on it display-side down.
4.Remove the two screws and then remove the
rear cover of the stand.
5.Remove the four screws and then remove the
stand from the TV.
Notes:
- If the stand is hard to remove, pull it toward
you while holding it up slightly.
- The stand is specially made for use with this
TV. Once having removed the stand, never
attempt to attach it to another equipment.
- Once having removed the screws, store them
together with the stand. If the stand is ever re-
attached, be sure to use the original screws.
Using different screws could lead to a
malfunction.
6.Attach the arm to the TV with the six screws.
Note:
- The screws used to attach the arm should be
M4 screws with a length of 10 mm protruding
from the surface to be attached.
Using different screws could cause the TV to
fall off or to be internally damaged.
Screw used to attach arm
Arm
Part of TV to which arm is
attached
10 mm
Soft cloth
02_LD-26SH3U_gb_02.P65 5/23/2005, 1:45 PM60