Filter
Top Products
13
Hookups and Settings
A: Cable box or satellite receiver with a video/audio output
With this hookup, you can record any channel on the cable box or satellite receiver. Be sure that the
satellite receiver or cable box is turned on.
To watch cable or satellite programs, you need to match the channel on the recorder (L1 or L3) to the
input jack connected to the cable box or satellite receiver (LINE IN 1 or 3). Note that satellite receiver
programs do not appear in the TV Guide On Screen system.
z Hints
• If your cable box or satellite receiver has an S-video jack or component output jacks, you can use an S-video cord (not
supplied) or component video cord (not supplied) instead of the audio/video cord. When you connect using a
component video cord, connect the audio cords to the LINE IN jacks.
• If you connect an S-video cord to the LINE IN 1 jack or a component video cord, set “Line1 Input” in Video Setup to
“S Video” or “Component” (page 89). If you connect an S-video cord to the LINE IN 3 jack, set “Line3 Input” in
Video Setup to “S Video” (page 89).
VHF/UHF
IN
COMPONENT VIDEO IN
LINE IN
DIGITAL OUT
VIDEO
S VIDEO
COAXIAL
OPTICAL
PCM/DTS/DOLBY DIGITAL
AUDIORL
1
3
LINE OUT
COMPONENT
VIDEO OUT
VIDEO
S VIDEO
AUDIORL
1
2
Y
P
B
P
R
Y
P
B
P
R
~ AC IN
OUT
SET TOP BOX
CONTROL
CONTROL S IN
G-LINK
ANT IN
RL
S VIDEO
AUDIO
OUT
VIDEO
OUT
COMPONENT
VIDEO OUT
TO TV
COMPONENT VIDEO IN
LINE IN
VIDEO
S VIDEO
AUDIORL
1
3
Y
P
B
P
R
SET TOP BOX
CONTROL
Set top box
controller
(page 12)
to LINE IN
1 or 3
DVD recorder
Audio/video
cord (supplied)
: Signal flow
Place the set top box controller
near the remote sensor on the
cable box/satellite receiver.
Cable box/
satellite receiver
Antenna cable
(supplied)
to antenna input
S-video cord (not
supplied)
to SET TOP BOX
CONTROL
Wall
TV
Component video cord
(not supplied)
Note
Do not connect a hi-
definition tuner using the
component video cords. This
recorder only accepts
standard definition interlace
signals.
to
COMPONENT
VIDEO IN
,continued